Production Process of Diesel Anti-Wear Agent

Diesel Anti-Wear Agent is a special additive that can improve the anti-wear performance of diesel engine oil. When the diesel engine is working, Diesel Anti-Wear Agent can reduce friction between metals, reduce wear and debris, and extend the service life of the diesel engine. The following is the production process of Diesel Anti-Wear Agent.

1. Raw material preparation: The raw materials required for the manufacture of Diesel Anti-Wear Agent mainly include ammonium molybdate, sodium molybdate, boric acid, organic amines, solvents, etc. These raw materials need to be quality tested to ensure that they meet relevant technical standards.

2. Diesel Anti-Wear Agent formula design: Design a suitable formula according to different requirements. Calculate the amount of each component based on the composition ratio and quality of each raw material in the formula.

3. Raw material processing: Add ammonium molybdate and sodium molybdate to the solvent according to the ratio in the formula, then heat and stir to fully dissolve them. Then add other raw materials such as boric acid and organic amines, and continue to stir and mix.

4. Filtration: Filter out impurities and insoluble solids generated during the production process through filtering equipment to improve the purity of the product.
5. Drying: Evaporate the filtered solution to dehydrate it and reach a certain dryness. This can be done by heating, low-temperature concentration, etc.

6. Packaging: Pour the dried Diesel Anti-Wear Agent into the packaging container and seal it tightly. At the same time, indicate the product name, specifications, manufacturer and other information.

7. Quality inspection: Perform quality inspection on the Diesel Anti-Wear Agent produced. Including appearance inspection, heavy metal content detection, pH value determination, solubility test, etc., to ensure that the quality of the product meets the requirements.

8. Storage and sales: Store and sell the Diesel Anti-Wear Agent that has passed the inspection. During storage, it is necessary to pay attention to moisture protection, sun protection, high temperature protection, etc. to ensure the stability and service life of the product.

The above is the production process of Diesel Anti-Wear Agent. The quality of each link needs to be strictly controlled during the production process to ensure that the products produced meet the standards and requirements. At the same time, it is also necessary to comply with relevant laws and regulations, protect the environment, and ensure the safety of the production process.